Century Breverra Ascend Series Instruction Manual

16, Century Breverra Ascend Series To prevent serious injury or death: • Use ONLY the vehicles Lap/Shoulder Belt system when restraining the child in this booster seat. • Shoulder belt MUST be properly positioned over shoulder (NOT touching child’s neck and NOT low off shoulder). • Lap/s…

34, 32 Removing Cup Holder: • Feel bottom of armrest and locate tab on bottom edge of cup holder. • Press tab in while lifting cup holder up. Tab Cup Holder Available on some models: • Locate slot in armrest and armrest pad on either side of car seat. • Snap cu…

9, 7 Without Harness System With Harness System Child MUST meet all of the following requirements: • Weight is 30 - 40 lbs. (14 - 18 kg). • Height is 35 - 43 inches (89 - 109 cm) tall. • Child is able to sit upright unassisted * . • Child’s shoulders are not above top ha…

12, 10 Place forward-facing on vehicle seat. Lift seat pad flap, check to make sure LATCH belt is properly routed through openings and attach LATCH belt to lower anchorage points (fig. a). Press down firmly in center of car seat to compress vehicle seat cushion while…

24, Century Breverra Ascend Series 22 VEHICLE SEAT BELTS If car seat with harness system is not held securely after following instructions in this manual, vehicle seat belt labels, and vehicle owner’s manual: • Move car seat to another seating location and try again, or • Contact vehicle dealer for p…

7, Century Breverra Ascend Series 5 Vehicle Top Tether Anchor Points Vehicle Lower Anchor Points Vehicle Seat Crease Typical seat in a passenger vehicle. Other vehicle types may have different LATCH locations. United States Federal Motor Vehicle Safety Standards have defined a new system for inst…

29, Century Breverra Ascend Series 27 Combination Lap/Shoulder Belt with Locking Latch Plate With Harness System: OK to use. Follow vehicle owner’s manual for specific instructions on how to use vehicle seat belts. The locking latch plate on some seat belts may slip and loosen after being buckled on car seat …

11, 9 Place forward-facing on vehicle seating position with a vehicle lap/shoulder belt. See “Placing child in car seat without harness system” pg. 14 & “Vehicle Seat Belts” section, page 22. INSTALLATION - without harness system and Vehicle Lap/Sho…

17, 15 (fig. a) (fig. c)(fig. b) Loops PLACING CHILD IN CAR SEAT - without harness system (continued) Comfort Clip ® …

25, 23 With Harness System: The locking latch plate on some seat belts may slip and loosen after being buckled on car seat if positioned at a certain angle. If this happens, flip latch plate over (fig. a) and re-buckle. Test installation again to see if this works. If not,…

14, Century Breverra Ascend Series 12 Adjust harness system: Harness straps MUST be through slots at or just above shoulders. Place child in car seat with child’s back flat against back of car seat. Place harness straps over child’s shoulders and insert tongues into buckle. Pull up on tong…