HP 6125G Configuration Manual

299, HP 6125G 288 Figure 81 SPT establishment in an IPv6 PIM-DM domain The flood-and-prune process takes place periodically. A pruned state timeout mechanism is provided. A pruned branch restarts multicast forwarding when the pruned state times out and then is pruned again when it n…

331, 320 Task Command Remarks Display information about join/prune messages to send. display pim ipv6 join-prune mode { sm [ flags flag-value ] | ssm } [ interface interface-type interface-number | neighbor ipv6-neighbor-address ] * [ verbose ] [ | { begin…

293, 282 Vlan-interface400 (4001::2): Total 1 MLD SSM-mapping Group reported Group Address: FF3E::101 Last Reporter: 4001::1 Uptime: 00:02:04 Expires: off # Display the IPv6 PIM routing table information on Switch D. [SwitchD] display pim ipv6 routing-tab…

4, ii Static port configuration example ·····················································································································…

134, 123 Ste p Command Remarks 3. Configure the BS period. c-bsr interval interval Optional. By default, the BS period is determined by the formula "BS period = (BS timeout timer– 10) / 2." The default BS timeout timer is 130 seconds, so the default …

173, 162 Creating an MSDP peer connection An MSDP peering relationship is identified by an address pair, namely, the address of the local MSDP peer and that of the remote MSDP peer. An MSDP peer connection must be created on both devices that are a pair of MSDP…

358, HP 6125G 347 Task Remarks optimizing IPv6 MBGP networks Enabling the IPv6 MBGP orf capability Optional Configuring the maximum number of equal-cost routes for load-balancing Optional Configuring a large scale IPv6 MBGP network Configuring an IPv6 MBGP peer group…

69, 58 { The router automatically chooses an optimal MBGP route by searching its MBGP routing table, and using the IP address of the packet source as the destination address. The outgoing interface in the corresponding routing entry is the RPF interface and the next …

10, viii Configuring an RP ·······························································································································�…

251, 240 Figure 67 Sub-VLAN-based IPv6 multicast VLAN After the configuration, MLD snooping manages router ports in the IPv6 multicast VLAN and member ports in the sub-VLANs. When forwarding multicast data to Switch A, Router A sends only one copy of multica…

315, HP 6125G 304 Ste p Command Remarks 2. Enter IPv6 PIM view. pim ipv6 N/A 3. Configure a static RP for IPv6 PIM-SM. static-rp ipv6-rp-address [ acl6-number ] [ preferred ] No static RP by default. Configuring a C-RP In an IPv6 PIM-SM domain, you c…

109, HP 6125G 98 Group Address Last Reporter Uptime Expires 232.1.1.1 133.133.4.1 00:02:04 off # Display PIM routing table information on Switch D. [SwitchD] display pim routing-table Total 0 (*, G) entry; 2 (S, G) entry (133.133.1.1, …

146, HP 6125G 135 Task Command Remarks Display the number of PIM control messages. display pim control-message counters [ message-type { probe | register | register-stop } | [ interface interface-type interface-number | message-type { assert | bsr | crp | graft | gra…

141, HP 6125G 130 Generally, a smaller distance from the filter to the multicast source results in a more remarkable filtering effect. This filter works not only on independent multicast data but also on multicast data encapsulated in register messages. To configure a multicast data …