Raven AccuBoom Installation Manual

14, CHAPTER 3 8 AGCO RoGator 64/74 Series AccuBoom™ Installation Manual INSTALL THE ACCUBOOM HARNESS CABLE For wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006) generously on both the male and female ends of the connectors. Application …

20, CHAPTER 4 14 AGCO RoGator 64/74 Series AccuBoom™ Installation Manual 655 655 77R 766 877 9** 10 10 R TABLE 2. 5 Section 7 Section Boom Wired As Displaye d As Boom Wired As Displaye d As …

6, CHAPTER 1 2 AGCO RoGator 64/74 Series AccuBoom™ Installation Manual • Lines and hoses carrying hot fluids beyond harness component specifications Avoid contact with any sharp edge or abrading surfaces such as, but not limited to: • Sheared or flame cut edges • Edges of …

9, Raven AccuBoom CHAPTER 2 Manual No. 016-0171-003 Rev. D 3 CHAPTER 2 INTRODUCTION Congratulations on your purchase of the Raven AccuBoom system! This system was designed to provide accurate and cost-efficient application by avoiding no-spray zones and eliminating wasteful overlaps. This ma…

26, Raven Applied Technology products that have been registered online are covered for an additional 12 months beyond the Limited Warranty for a total coverage period of 24 months from the date of retail sale. In no case will the Extended Warranty period exceed 36 months from the …

21, CHAPTER 5 Manual No. 016-0171-003 Rev. D 15 CHAPTER 5 TROUBLESHOOTING The AccuBoom CAN control node (P/N 063-0172-316) features several green light-emitting diodes (LEDs) which may be used to diagnose issues within the AccuBoom system. NOTE: If the LEDs are not displayed as outl…

11, Manual No. 016-0171-003 Rev. D 5 INTRODUCTION TABLE 1. AGCO RoGator 64/74 Series (2006 and older) AccuBoom Installation Kit (P/N 117-1004-010) TABLE 3. AGCO RoGator 1274 7-Boom (2007 and 2008) AccuBoom Installation Kit (P/N 117-1004-022) TABLE 2. Picture Item Descript…

7, Raven AccuBoom Manual No. 016-0171-003 Rev. D 3 IMPORTANT SAFETY INFORMATION • Inspect all electrical components and connections for damage or corrosion. Repair or replace components, connections, or cable as necessary. • Ensure connections are clean, dry, and not damaged. Repair or repla…

19, Raven AccuBoom CHAPTER 4 Manual No. 016-0171-003 Rev. D 13 CHAPTER 4 SECTION MAPPING SETUP This section contains section mapping settings that are used to program the AccuBoom controller. Refer to the Installation & Operation Manual and the appropriate section in this chapter for…

13, CHAPTER 3 Manual No. 016-0171-003 Rev. D 7 CHAPTER 3 ACCUBOOM INSTALLATION These instructions are designed to assist in the installation of the AccuBoom system on AGCO RoGator 64 and 74 Series machines. Refer to the Installation & Operation manual for the specific field com…