AMC 210 Series Instructions Manual

5, AMC 210 Series AMC-210 Transmitter with external electrochemical sensor 3 1 WARRANTY The AMC-210 transmitter is warranted against defects in material and workmanship for two (2) years from the date of shipment from factory. Please check equipment specifications followi…

19, AMC 210 Series AMC-210 Transmitter with external electrochemical sensor 17 7 ADDENDUM (FOR OXYGEN ONLY) This AMC-210 Series (2-wire sensor/transmitter with external electrochemical sensor) has been modified and the following information replaces the terminal block & sensor …

3, AMC 210 Series AMC-210 Transmitter with external electrochemical sensor 1 TABLE OF CONTENTS Section Title Page 1 WARRANTY...........................................................…

15, AMC 210 Series AMC-210 Transmitter with external electrochemical sensor 13 5.2.1 EQUIPMENT REQUIRED • Digital multimeter with a minimum display range of 20.0 mA. • Remote calibration lead provided with the transmitter. • Miniature screwdriver trimmer adjustment tool. • Ca…

9, AMC-210 Transmitter with external electrochemical sensor 7 4 INSTALLATION 4.1 LOCATION AND MOUNTING Mount the sensor/transmitter on a solid, non-vibrating surface or structure in an area where the local concentration of gas is unaffected by the presence…

17, AMC-210 Transmitter with external electrochemical sensor 15 6 PREVENTIVE MAINTENANCE 6.1 GENERAL The sensor/transmitter unit should be brushed or wiped clean of any dust or dirt at least once a year or more, depending on the rate of accumulation. To av…

7, AMC-210 Transmitter with external electrochemical sensor 5 3 PRODUCT DESCRIPTION 3.1 GENERAL DESCRIPTION The AMC-210 series sensor/transmitter is designed to provide continuous, reliable surveillance of surrounding air for traces of a specific hazardous gas(es) (…

12, AMC-210 Transmitter with external electrochemical sensor 10 4.2.1 TRANSMITTER TO MONITOR WIRING The transmitter output (–, +) terminals connect to the (SIG, +) terminals on a channel terminal block of the monitor (one transmitter per channel), as shown in Figure…

6, AMC 210 Series AMC-210 Transmitter with external electrochemical sensor 4 2 PRODUCT INFORMATION 2.1 SENSOR/TRANSMITTER Sensor/Transmitter Unit Order Number. ………………… Transmitter Part Number..…………………………………… Transmitte…

14, AMC-210 Transmitter with external electrochemical sensor 12 5 OPERATION AND CALIBRATION 5.1 OPERATION The AMC-210 series sensor/transmitter is factory calibrated for the gas listed in Product Information (section 2) at the beginning of this manual. The sensor/transmit…

10, AMC-210 Transmitter with external electrochemical sensor 8 4.2 CABLE SELECTION AND WIRING Connection should be made using 2-conductor, shielded cable. For best signal transmission and maximum noise rejection, run cable through steel conduit (cable must be grounded…

13, AMC-210 Transmitter with external electrochemical sensor 11 4.2.2 INTERFACING TO COMPUTER, DATALOGGER, OR NON-AMC MONITOR All Armstrong sensor/transmitters can be connected to computers or data loggers through analog-to-digital converters or to non-AMC monitors. Th…