Nonin 9847V Operator's Manual

57, Nonin 9847V 50 Technical Information Principles of Operation Pulse oximetry is a non-invasive method that passes red and infrared light through perfused tissue and detects the fluctuating signals caused by arterial pulses. Well-oxygenated blood is bright red, while poorly oxygenated b…

39, 32 Using the 9847V Pulse Oximeter Audible alarms re-enabled via Audible Alarm Disable button or ending of 2-minute disable When the audible alarms are re-enabled, and at least one alarm condition exists, the sound cycle for the highest priority alarm condition in eff…

37, Nonin 9847V 30 Using the 9847V Pulse Oximeter SpO 2 high or low High priority animal alarm SpO 2 numeric display blinking; if latched for critical battery state, displays blinking dashes in all 3 LEDs. Pulse rate high or low High priority animal alarm Pulse rate numeric displa…

21, Nonin 9847V 14 Displays and Indicators Displays and Indicators The following is an overview of the device’s displays and indicators (figure 2). See “Visible Indicators” on page 23 for more detailed information. SpO 2 Display Identified by the %SpO 2 symbol, this 3-digit light-emi…

35, 28 Using the 9847V Pulse Oximeter Critically Low Battery Alarm The audible critically low battery alarm is a medium priority equipment alarm indicating the batteries have reached a critically low level and must be replaced immediately. The 9847V will not monitor a…

43, Nonin 9847V 36 Care and Maintenance Care and Maintenance 1. Wipe the device with a soft cloth dampened with a mild detergent or 10% bleach solution. Do not use undiluted bleach or any cleaning solution other than those recommended here, as permanent damage could result. 2…

25, 18 Using the 9847V Pulse Oximeter Event Marker Press Alarm Limit Review to activate an event marker. Marked events will display as an asterisk (*) at the end of the real-time data output. Carbon Dioxide Detector Startup Verify: 1. Airway adapter tube is properly attached to t…

31, 24 Using the 9847V Pulse Oximeter SpO 2 and Pulse Rate Displays A pulse oximeter sensor fault occurs if the 9847V pulse oximeter detects a sensor disconnect, dislodgement, or failure. If a pulse oximeter sensor fault occurs or a sensor signal is no longer detected, a…

27, Nonin 9847V 20 Using the 9847V Pulse Oximeter Disabling the Audible Alarms The audible alarms can be temporarily disabled, or they can be permanently disabled at power on when entering setup mode using the Audible Alarm Disable button. When the audible alarms are disabled, infor…

8, 1 Indications for Use Indications for Use The Nonin Model 9847V Veterinary Pulse Oximeter and Carbon Dioxide Detector is indicated for use in measuring and displaying functional oxygen saturation of arterial hemoglobin (SpO 2 ), pulse rate, and approximate carbon dioxide (CO 2 …

47, 40 Communications Connecting the Device into a Medical System Incorporating the device into a medical system requires the integrator to identify, analyze, and evaluate the risks to patient, operators, and third parties. Subsequent changes to the medical system after device inte…

3, Nonin 9847V i Contents Indications for Use.................................................................................................... 1 Pulse Oximeter Intended Use................................................................................. 1 Carbon Dioxide Detector Intended U…

29, 22 Using the 9847V Pulse Oximeter No Breath Delay Time Setting 1. Upon entering no breath delay time setup, “nbd” appears in the SpO 2 display. The no breath delay time may be set from 15 to 60 (seconds) in increments of 5, or to OFF. 2. When the no breath delay…