AEG LAVAMAT 72640 Operation & User’s Manual

4, AEG LAVAMAT 72640 At the end of the programme 18 Child safety lock 18 Washing programmes 20-21 Programme informations 22 Preparing the wash cycle 23-27 Sorting out the laundry 23 Temperatures 23 Before loading the laundry 23 Maximum loads 24 Laundry weights 24 Removing stains 25 Detergent…

39, AEG LAVAMAT 72640 39 Consumption value The consumption data shown on this chart is to be considered purely indicative, as it may vary depending on the quantity and type of laundry, on the inlet water temperature and on the ambient temperature. It refers to the highest temperature for each wash…

10, 10 Control panel Control panel First Use Ensure that the electrical and water connections comply with the installation instructions. Remove the polystyrene block and any material from the drum. Pour 2 litres of water into the main wash compartment of the detergent draw…

3, Contents Instruction for the user 6 Safety information 6-8 Product description 9 Detergent dispenser drawer 9 Control panel 10 First use 10 Personalization 11 Acoustic signals 11 Daily use 11 Laod the laundry 11 Measure out the detergent and the fabric softener 11 Selec…

30, AEG LAVAMAT 72640 2. Remove the conditioner insert from the middle compartment. 3. Clean all parts with water. 4. Put the conditioner insert in as far as it will go, so that it is firmly in place. 5. Clean all parts of the washing ma- chine, especially the nozzles in the top of the wa…

38, AEG LAVAMAT 72640 38 Technical data Techinical Data Dimensions Width Height Depth (door included) 60 cm 85 cm 63 cm Electrical connection Voltage - Overall power - Fuse Information on the electrical connection is given on the rating plate on the inner edge of the appliance door Water supply press…

32, 32 Care and cleaning 8. Put the cap back on the emergency emptying hose and place the latter back in its seat. 9. Screw the pump fully in. 10. Close the pump door. Warning! When the appliance is in use and depending on the programme selected there can be hot water in the…

31, Drain pump The pump should be inspected regularly and particularly if • the machine does not empty and/or spin • the machine makes an unusual noise during draining due to objects such as safety pins, coins etc. blocking the pump. Proceed as follows: 1. Disconnect the applia…

14, Select the Prewash option Select this option if you wish your laundry to be prewashed at 30°C before the main wash. The Prewash ends with a short spin in programmes for cotton and synthetic fabrics, whereas in the programmes for delicate fabrics the water is only draine…

33, AEG LAVAMAT 72640 7. replace the emergency emptying hose in its seat after having plugged it; 8. screw the pump again and close the door. Frost precautions If the machine is installed in a place where the temperature could drop below 0°C, proceed as follows: 1. Close the water tap and …

35, 35 Something not working Problem Possible cause/Solution The machine fills then empties immediately: The end of the drain hose is too low. • Refer to relevant paragraph in «water drainage» section. The machine does not empty and/or does not spin: The drain hose is…

17, AEG LAVAMAT 72640 17 Use You must select this option after you have set the programme and before you press the Start/Pause button. The wash programme can be delayed from 30 min - 60 min - 90 min, 2 hours and then by 1 hour up to a maximum of 20 hours by means of this button. If you…

27, Degrees of water hardness Water hardness is classified in so-called “degrees” of hardness. Information on hardness of the water in your area can be obtained from the relevant water supply company, or from your local authority. Note: A water softener must be added when wa…

36, 36 Something not working No water is visible in the drum: Machines based on modern technology operate very economically using very little water without affecting performance. Problem Cause possible/Solution The door will not open: The programme is still running. …

43, 3. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks. 4. Connect the hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance. Installation should comp…